Transmision O/D light test with the O/D button on the gear shift on a 96/Villager GSAssuming you have a 96. Trans test If using overdrive off lamp (ODL): No equipment hookup needed. Locate the overdrive on/off switch. AT5 PERFORM DIAGNOSTIC TEST MODE If using OD Off Lamp: Key OFF. Place the gearshift lever in P range. Key ON. ODL should come on for two seconds; if not, go to Section 6B, Pinpoint Test TB . Key in OFF, but not LOCK position. Move the gearshift lever to D range. Hold the OD on/off switch button in. Turn the key ON while holding the OD on/off switch button in, and wait for more than two seconds. Keep holding the OD on/off switch button in while moving the gearshift lever to 2 range. Release the OD on/off switch button. Set the OD on/off switch to ON position. Move the gearshift lever to 1 range. Set the OD on/off switch to OFF position. Depress the accelerator pedal fully then release it. Observe the ODL. Record the DTCs. AT6 ERASE AND RETEST Note: Erasing DTCs and retesting will give an indication whether DTCs received in Test Step AT5 are hard or intermittent faults. Hard faults will be repeated immediately and DTCs will be displayed during retest. TCM Diagnostic Trouble Code Chart Fuse Panel DLC 2 Digit TCM DTC Component Pinpoint Test - Transmission Range Sensor Circuit Malfunction TD 08 Transmission Fluid Temperature (TFT) Sensor Circuit Malfunction TE - Pulse Signal Generaotr (PSG) TF 09 Engine Speed Input Circuit Malfunction ND - Gear 1 Incorrect Ratio ...
Keywords: Villager, Quest, 1996, 1997, 1998, Trany, Transmission, CEL, Light, Test, Vitally
No comments:
Post a Comment